Multipurpose (Orange)
This LED indicates the reception of a DMX or ArtNET signal
In [Artnet] mode:
Off No active ArtNET signal detected
Steady pulse ArtNET signal detected
In all other modes:
Off No active DMX signal detected
Steady pulse DMX signal detected
Laser Emission status (Red) (All modes)
OFF No laser output
Steady pulse Software connection established
Blinking Laser output enabled
In [Timecode] mode:
Off No Art-net Timecode signal detected
Double flash every second Preparing data for timecode management
Steady pulse FB4 is ready to receive Timecode
In [Slave mode] mode:
Off No master detected
Steady pulse master device detected
In [ILDA mode]
Off Shutter Closed
Steady Pulse ILDA cable connected
Blinking Laser output enabled
Note: During a firmware update of the FB4 all four indication leds will be fully on.
Note: If all four LEDs are blinking together, the FB4 has no valid firmware loaded and there
is no valid firmware on the SD card.
To Next Page
Loading...