640 Icon LCD Keypad 27n
Trouble [6]: Fail to Communicate PC
The control panel is unable to communicate with the WinLoad software.
If a trouble occurs from either Group [3] or [4], call your
installer.
8.0.3 Group [5]: Zone Tamper
Indicates that one or more zones have been in tamper. The
numerical LEDs for the zone or zones that have been tampered with
will be illuminated.
8.0.4 Group [6]: Zone Low Battery
Indicates that a wireless device's battery needs to be replaced. The
numerical symbols for the zone that it is assigned to will be
illuminated. Also, the yellow light on the device will flash to indicate
this trouble.
8.0.5 Group [7]: Zone Fault
Indicates that a smoke detector is experiencing a wiring problem and
needs to be cleaned or that a wireless device is no longer
communicating with its receiver.
8.0.6 Group [8]: Clock Loss
Indicates that the time and date have been reset to the default. This
is the only trouble that we recommend you correct.
How do I set the time within the Trouble Menu?
Refer to Programming the Time on page 30 for a detailed
explanation of the two time formats.
DGP2640_EU00.fm Page 27 Friday, April 8, 2005 11:28 AM
To Next Page
Loading...
Need help?
General
