- 28 -
EVENT REPORTING
[0]
Ademco Slow
[3]
Ademco Express
Pulse
[1]
Silent Knight Fast
[2]
Sescoa
DTMF
(Tone)
Program 2-digit (00-FF)
report codes into sections
[600] to [702] where each
section represents up to 4
events in the system.
[5]
Ademco Contact I.D.
[7]
Pager
[6]
SIA FSK
Central Station Telephone
Numbers 1 through 4
32 digits Sections [561] to [564]
Reporting Account
Numbers
Reporting Account Number 1
3 or 4 digits (0-F) in Section [551]
Partition 1
Reporting Account Number 4
3 or 4 digits (0-F) in Section [554]
Reporting Account Number 3
3 or 4 digits (0-F) in Section [553]
Reporting Account Number 2
3 or 4 digits (0-F) in Section [552]
Partition 4
Partition 3
Partition 2
Event Call Direction
Defines which Central
Station Telephone
Numbers each specific
group of events will be
reported to.
[1] = Call Central Telephone 1
[2] = Call Central Telephone 2
[3] = Call Central Telephone 3
[4] = Call Central Telephone 4
[5] = Backup on Telephone 1
[6] = Backup on Telephone 2
[7] = Backup on Telephone 3
[8] = Backup on Telephone 4
For each section (dialing sequence) you
can enable up to 4 central station telephone
numbers and 1 of four back-up telephone
numbers. The numbers are dialed
sequentially from 1 to 4 followed by the
back-up number. Continuing this sequence
until each number has been dialed at least
once.
Reporting Formats
Section [550]
1
st
digit = CSTN#1
2
nd
digit = CSTN#2
3
rd
digit = CSTN#3
4
th
digit = CSTN#4
Related Features
Delay Before Alarm Transmission
Section [256]
Pager Format Delay Transmission
Section [259]
Recent Closing Delay
Section [219]
Power Failure Report Delay
Section [260]
Auto Test Report
Sections [261] & [270]
Report Disarm Options - Option [7]
Section [506], [510], [514], [518]
Report Zone Restore Options - Option [8]
Section [522]
Alternate Dial
Option [6] - Section [522]
Dialing Enabled/Disabled
Option [3] - Section [521]
Dialing sequences for Arm/Disarm Report Codes
Partition 1 = Section [523] Partition 3 = Section [529]
Partition 2 = Section [526] Partition 4 = Section [532]
Dialing sequences for Alarm/Restore Report Codes
Partition 1 = Section [524] Partition 3 = Section [530]
Partition 2 = Section [527] Partition 4 = Section [533]
Dialing sequences for Tamper/Restore Report Codes
Partition 1 = Section [525] Partition 3 = Section [531]
Partition 2 = Section [528] Partition 4 = Section [534]
Dialing sequence for Trouble/Restore Report Codes
Section [535]
Dialing sequence for System Special Report Codes
Section [536]
Delay Between
Dialing Attempts
Section [258]
Maximum Dialing
Attempts
Section [257]
Figure 9.1 - Event Reporting
CSTN = Central Station
Telephone Number
Sections [790] to [795]
Manual & Automatic programming of
report codes, please refer to sections
9.5.3, 9.5.4 and 9.13 for details
To Next Page
Loading...
Need help?
General
