- 34 -
9.12 PAGER DELAY
Section [259]
When using the Pager Reporting Format (see section
9.5.5), the control panel will wait for the delay period
(001 to 060 seconds) programmed into section [259]
before uploading the report codes to the pager. This
is to allow time for the pager system to provide a dial
tone or to bypass the “welcome” message before
sending data.
9.13 AUTO REPORT CODE
PROGRAMMING
Sections [790] to [795]
When using either the Contact ID or SIA Reporting
Formats (see section 9.5), the Digiplex system can
automatically program a set of default report codes.
From programming mode (see section 3.2) enter any
of the following sections to set the indicated report
codes:
Section [790] – ALL CODES
Sets all report codes in sections [600] to [702] with
the default values from the “Automatic Report Codes
List” in the Programming Guide.
Section [791] – ARMING & DISARMING CODES
Sets all report codes in sections [600] to [638] with
the default values from the “Automatic Report
Codes List” in the Programming Guide.
Section [792] – ALARM RESTORE CODES
Sets all report codes in sections [639] to [664] with
the default values from the “Automatic Report
Codes List” in the Programming Guide.
Section [793] – TAMPER & TAMPER RESTORE CODES
Sets all report codes in sections [665] to [689] with
the default values from the “Automatic Report
Codes List” in the Programming Guide.
Section [794] – TROUBLE RESTORE CODES
Sets all report codes in sections [690] to [700] with
the default values from the “Automatic Report
Codes List” in the Programming Guide.
Section [795] – SPECIAL CODES
Sets all report codes in sections [701] to [702] with
the default values from the “Automatic Report
Codes List” in the Programming Guide.
Please note that even after automatic report
codes have been set, you can still use the
manual programming method (see sections
9.5.3 & 9.5.4) to program remaining report
codes or change some of the defaults.
To Next Page
Loading...
Need help?
General
