EN
eFlow
®
rapid nebuliser system – Questions about your device? Contact your service partner 21
en
H Assembling Your Nebuliser System
Step H6 Attach the connection cord to the nebuliser
handset.
Line-up the bottom of the connector (a) with the
bottom of the nebuliser handset (b).
Lift until the tab on the connection cord (c) snaps
into the rear underside of the nebuliser handset.
Fig. H6
Step H7 Attach the connection cord to the controller.
Attach the rectangular end of the connection
cord (a) to the bottom of the controller.
Fig. H7
b
c
a
a
To Next Page
Loading...
