EN
eFlow
®
rapid nebuliser system – Questions about your device? Contact your service partner 27
en
J Controller Settings
Step J2 Change backlight settings. In the first step, you
can make changes to the backlight. By repeated
pressing of the ON/OFF button you can choose
between the options "Default" (Fig. J2a), "Backlight
always ON" (Fig. J2b) and "Backlight always OFF"
(Fig. J2c). In the delivered state, the option
"Default" is selected: Backlight switches on for
1 second when button is pressed, or the device sta-
tus changes.
Fig. J2a
Default
Fig. J2b
Backlight always ON
Fig. J2c
Backlight always OFF
Step J3 Apply preferred setting. Navigate to your pre-
ferred setting. Wait until the controller automatically
saves the selection after a few seconds. The con-
troller confirms this with a checkmark (Fig. J3).
Fig. J3
To Next Page
Loading...
