Installing the Drive 3-9
650 Series AC Drive
LED Indications
The module has three LEDs providing diagnostic
information about the 650 host drive's ‘Health’,
‘Receive’ and ‘Transmit’ activity.
HEALTH = Green, Rx = Red, Tx =Red
LED Name LED Duty Drive State
HEALTH
SHORT FLASH
Re-configuration, or corrupted non-volatile
memory at power-up
EQUAL FLASH
Tripped
ON
Healthy
LONG FLASH
Braking
OFF
No drive power, or serious hardware fault
Rx
INTERMITTENT
Indicates activity on the ‘receive’ line carrying
data from the Master
Tx
INTERMITTENT
Indicates activity on the ‘transmit’ line carrying
data to the Master
Configure the Drive
Before the module can be used you must configure the drive to your system. Set-up the
parameters in the SERIAL menu as appropriate. Refer to Chapter 6: "Programming Your
Application" - SET::SERL Menu, parameters
S
SE01 to
S
SE08.
For Tag number information refer to the 650 Software Product Manual, available on the Parker
SSD Drives website: www.SSDdrives.com.
Note: This Option can only be used on drives using software version 4.1 or higher.
Lefflersgatan 1, SE-754 50 Uppsala, SWEDEN +46 (0)18-65 70 00 +46 (0)18-10 74 78 info@regal.se www.regal.se
To Next Page
Loading...
