Serial Communications 11-1
650 Series AC Drive
5SERIAL COMMUNICATIONS
Connection to the P3 Port
IMPORTANT: The drive MUST be earthed. Failure to do so could damage your communications ports.
The port is an un-isolated RS232, 19200 Baud. Contact Parker SSD Drives for further
information.
The P3 port is located under the terminal cover and is used only by the remote-mounted RS232
Keypad.
P3 Port
A standard P3 lead is used to connect to the drive.
1 2 3 4
P3 Port Pin Lead Signal
1 Black 0V
2 Red 5V
3 Green TX
4 Yellow RX
Note: There is 5V present on pin 2 of the P3 port - do not connect this to your PC.
Lefflersgatan 1, SE-754 50 Uppsala, SWEDEN +46 (0)18-65 70 00 +46 (0)18-10 74 78 info@regal.se www.regal.se
To Next Page
Loading...
