5.3.2 Connecting Analog Sensors
Fig.9 Connecting analog sensors
Connect the sensors in the following sequence:
1 Connect the sensors on the application side (e.g. pressure/temperature
sensor connection).
2 Connect each sensor to an analog cable.
3 Connect the analog cable to the corresponding port on the device.
IMPORTANT
The device does not record data from sensors which are connected while a
measurement is in progress.
Restart the measurements in order to record data from sensors just connect-
ed. Measuring data from sensors which are disconnected while a measure-
ment is in progress is recorded by the device to the moment of disconnection.
24
The Parker Service Master COMPACT V1.0/02/24
Starting Up
To Next Page
Loading...
