Parker COMPACT - Completing a Measurement

6.6 Completing a Measurement
The description below explains how to complete a measurement according to
an example:
1 Switch the device on.
► Further information is available in Chapter & „Switching the Device On
and Off“ on Page22.
2 Connect the sensors to the device according to your application.
► Further information is available in Chapter & „Connecting Sensors“ on
Page23.
3 Setup the channels displayed according to your application.
► Further information is available in Chapter & „Options: Edit Channels
in the Measurement View (Edit Channels)“ on Page41.
4 Select a measurement method.
► Further information is available in Chapter & „Measuring Methods“ on
Page50.
5 Tap the Start
button to start a measurement. Alternatively, wait until
the defined trigger is triggered.
Ä The measurement starts up.
6 Tap the Stop
button to stop a measurement. Alternatively, wait for the
defined storage time to expire.
Ä The measurement is stopped.
After the measurement is stopped, the data is saved in the device memory or
on a connected USB data carrier.
You can access the data via the File Manager in order to carry out evaluations.
► Further information is available in Chapter & „File Manager“ on Page58
55
The Parker Service Master COMPACT V1.0/02/24
Operation