Set trigger
With the Trigger function, the measurement waits for a defined measurement
signal threshold to be triggered. The prerequisite is that the Trigger function in
the Datalogger measurement method has been set according to your applica-
tion:
1 Tap on the Datalogger measurement method.
Ä The settings for carrying out the measurement are displayed.
2 Tap on the Trigger button to activate the function.
Ä The Trigger settings are displayed.
Fig.32 Trigger, settings
The following settings are available:
Designation Description
Trigger input Select the channel that serves as the trigger (only the
channels of connected sensors are displayed)
Trigger-level Specify the measured value that serves as the trigger
Trigger-slope Select whether the trigger is triggered on a rising
edge (Rising) of the measured value or on a falling
edge (Falling)
54
The Parker Service Master COMPACT V1.0/02/24
Operation
To Next Page
Loading...
