Parker COMPACT - Mounting Device on VESA Holder

5.5 Mounting Device on VESA Holder
You can mount the device using the VESA holder (75mm × 75mm) on the rear
side.
Fig.11 Mounting device on VESA holder
Mount the device in the following sequence:
1 Assemble the VESA holder at the installation location.
► Observe the information in the manual supplied with the VESA holder.
2 Mount the device on the VESA holder.
3 Screw the device using four retaining screws and an appropriate tool.
Ä The device is mounted.
INFORMATION
The maximum screw-in depth for the retaining screws is 6mm. The VESA
holder and screws necessary for assembly (M4 metric) are included in the
supply package.
26
The Parker Service Master COMPACT V1.0/02/24
Starting Up