Peekel Instruments User manual PICAS V2.6.1
Page 41 of 59
3.5.7 System-menu: Password
This menu is only available when the PB6100 controller is in use.
In this menu a password can be entered, to protect the instrument settings in nonvolatile
memory to be overwritten.
When the correct password is entered, the command to store the settings is available.
When the used has “logged off” the settings can be altered but cannot be stored.
Set password :
Log off :
****
<execute>
<execute>
MENU
Password
Controls and Functions
Datalogging selectable (Inactive / Cyclic Log / Log & Fill RAM)
Password editable a numeric value can be entered here, which is
larger then –32000 and smaller then +32000.
Set password <execute> When this command is given the entered
password is saved and made active
Log off: <execute> After this command, the entered password is
erased, and the protection is activated
Functional Description
This menu is only available when the correct password is entered in the “Memory menu” or
if the password protection is not activated.At the first line a password can be entered.
Choose a numeric value between –32000 and 32000, enter this value and give the
command “Set password”. Now the password is saved in nonvolatile memory. To enter the
protected mode, give the command “Log off”. Because this menu is only available in the
non-protected mode, this menu will immediately disappear when the “Log off” command is
entered.
To Next Page
Loading...