PRUNING SHEARS C3X
26_176804-B
6. MAINTENANCE
6.1. FREQUENCY OF OPERATIONS
Caution
• All maintenance operations must be carried out with the battery disconnected from the tool,
unless otherwise specified in the procedure.
• Use products recommended by PELLENC.
• In the event of any problem, consult an authorised PELLENC dealer.
Maintenance schedule
Frequency of operations
Operations
At each
start-up
1
Every 4
hours
Every week After use
Visually check the general condition of the tool.
See 6.3.2. Visual check of the general condition of the
tool, page 28.
X
Check the operating trigger.
See 6.3.3. Checking the operating trigger, page 28.
X
Check the sharpness of the blade.
See 6.4. Sharpening the blade, page 29.
X
Check the tightness of the blade.
See 6.5. Check the tightness of the blade, page 30.
X
Check the crossing over of the hook and the blade.
See ???.
X
Clean the tool (blowing or brushing, not high pressure
jet cleaning).
See 6.7. Cleaning the tool, page 30.
X
Grease the blade.
See 6.6. Greasing the blade, page 30.
X
Check the functioning of the Activ' Security.
see 6.3.1. Checking the operation of the Activ'Security
and the conductivity of the gloves, page 27
X X
Check the condition of the gloves and their
conductivity.
see 6.3.1. Checking the operation of the Activ'Security
and the conductivity of the gloves, page 27
X X
Check the battery charge level. X X
Have the tool checked by a PELLENC authorised
dealer.
Important
Have the machine serviced every 400 hours
or at least once a year by a PELLENC
authorised dealer. Always store the tool clean
and in a dry place, with the battery charged.
Changing the blade kit
See 6.8. Changing blade or shaft, page 31.
EVERY 200 HOURS or as necessary to maintain
a good quality cutting, replace the blade.
Battery Please refer to the battery operating instructions.
26
To Next Page
Loading...
