PRUNING SHEARS C3X
26_176804-B
7.3. SUMMARY OF PRUNING SHEAR STATUS INDICATOR LIGHT CODES
Normal operation Codes
Use
Blinking green • The pruning shears are on standby
Steady green • The pruning shears are active
Error codes
Note
In the event of an error, the red indicator light lights up and flashes very rapidly, and the green indicator
light flashes a number of times depending on the error.
Green indicator light flashing once • The pruning shears are in overcurrent or undervoltage
Green indicator light flashing twice • Trigger position fault detected
Green indicator light flashing three times • Motor rotation sensor fault detected
Green indicator light flashing four times • Ball nut position sensor fault detected
Green indicator light flashing five times • Tool overheating
Green indicator light flashing six times • The electronic circuit board is damaged. Can only
occur at start-up
Green indicator light flashing seven times • Fault detected with Activ' Security
Green indicator light flashing eight times • Fault detected with the software
36
To Next Page
Loading...
