BRUSH CUTTER EXCELION 2 DH
53_153238-A
Tall grass mowing
• To mow tall, dense grass, mow the upper part first, then
the lower part.
• The mowing movement is from right to left while left to
right is the return movement.
• Mowing in one direction only helps with the disposal
of cut grass.
Mowing on slopes
Important
Before starting to mow on a slope, make sure you
are stable on the ground.
1. Position yourself at the base of the slope.
2. Define a strip parallel to the slope that spans the
width of the work area.
Movement to be performed
• The operator must always work with the same movement with the arms: start at the highest side of the slope
and finish his movement towards the bottom of the slope. This will allow the freshly cut grass to fall down slope.
This will prevent the cutting attachment from turning in the grass that has already been cut.
Direction of progression
• The operator must always walk forward, following the strip defined at the start of the work.
• When said strip is finished, the user must retrace his steps and start a new strip slightly higher than the one
which has just been completed.
Mowing along walls, fences, around trees
and flower beds
• Use the TAP CUT 3 and its strimmer wire as this faci-
litates the removal of grass and avoids the phenome-
non of kickbacks when in contact with a fixed obstacle.
• Protect bark and the edge of flower beds by using the
safety guard as a shield between the surface area to
be cleared and the vegetation to be protected.
61
To Next Page
Loading...
