EasyManua.ls Logo

Pentair EASYTOUCH PL4 - Solar System Installation; Solar System Start-Up

Pentair EASYTOUCH PL4
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EASYTOUCH
®
PL4/PSL4 Control System Installation Guide
EASYTOUCH
®
PL4/PSL4 Control System Installation
33
Solar System Installation
• Toensuremaximumowofwaterthroughthesolarpanels,asolarboosterpumpshould
be added if panels are installed at a very high elevation.
• Itisrecommendedthatthesolarpanelsaremountedinawaythatgravitywillallow
drainingwheneverthelterpumpisnoton.
• Forsystemswithglazedpanels,damagecanoccurfromoverheatingifthelterpumpis
stillrunningafterthesolarhasturnedoff.Toenableglazedpanelstoautomaticallydrain
wheneverthesolarturnsoff(evenifthelterpumpisstillrunning),a1/2”motorizedsolar
drainvalveshouldbeplumbedfromthesolarfeedline,throughacheckvalve,toazeropsi
point(suchaspoollllineorjetairintake).
SolarSystemStart-Up
1. Switch power on to the EasyTouch PL4/PSL4 Control System Power Center.
2. If pool cleaner protection has been added to the system, the pool cleaner pump motor
shouldbeactivatedwheneverthepoolcleanertimerison.Momentarilyturnpoolcleaner
on and off to check the motor is operating correctly.
3. CheckthatSolarValveisin“solarbypass”position,divertingwaterawayfromsolarpanels.
If Solar Valve is staged incorrectly (diverting water to the solar panels), reverse switch on
back of Valve Actuator (change from ON1 to ON2, or vice-versa). The Valve Actuator will
automatically rotate to the correct position.
4. CheckthatSolarValvehasrotatedfromthe“solarbypass”positiontothe“solar”position,
diverting water through the solar panels.
5. The system is now ready to be operated as desired.
Pool Cleaner Protection
Recommendedforuseinpoolsystemswhichutilizea“boosterpump”poolcleaner.Thisfeature
automatically turns off the pool cleaner pump for a few minutes whenever solar is initiated. This will
protect the pump from damage caused by air in the solar panels at system start-up.

Table of Contents

Other manuals for Pentair EASYTOUCH PL4

Related product manuals