Pentair FLECK 2850 SXT - Programming; Display

Installer manual Fleck 2850 SXT - Programming
Ref. MKT-IM-030 / C - 12.05.2020 49 / 104
6 Programming
6.1 Display
1. Service icon • Appears in service mode;
• Flashes if a regeneration cycle has been queued.
2. Error /
Information icon
• Appears in case of error, see Troubleshooting [
→
Page86], or in
diagnostic mode, see.Diagnostic [
→
Page61]
3. Parameter
display
Master programming and diagnostic modes:
• C: Unit capacity;
• CD: Current day;
• CT: Regeneration control type;
• DF: Display format;
• Dn, n=1 to 7: Day of week;
• DO: Days override;
• FM: Flow meter;
• FR: Current flow rate;
• H: Feedwater hardness;
• HR: Hours in service;
• K: Meter pulse;
• NT: Number of tanks;
• PF: Peak flow rate;
• RC: Reserve capacity;
• RF: Regeneration flow;
• RS: Reserve selection;
• RT: Regeneration time;
• SF: Safety factor;
• SV: Software version;
• TD: Time of day;
• TS: Tank in service;
• VU: Volume used.