Installing the Power Center
Install the Power Center at eye level as close to the IntelliChlor pump and filtration as possible
CAUTION: The Power Center must be installed more than 2.44 m (8 ft.) from the pool edges
Leave sufficient clearance on all sides of the Power Center. Ensure that the 4.57 meters (15 ft.) “Type Z” DC
power cord from the Cell assembly pipe location can reach the Power Center location. The Power Center
enclosure can be mounted on the wall up to 4.57 meters (15 ft.) away from the cell controller.
Note: For installation instructions about connecting the cell to Power Center, see the “IntelliChlor
User’s Guide” (P/N 520589).
Mount the Power Center enclosure:
1. Remove the screw securing the Power Center cover and remove the cover.
2. Mount the Power Center on a flat surface such as a wall or post and mark each mounting bracket
screw hole location. There are two (2) screw holes and a keyslot for the top and lower bracket.
3. Drill six ¼ inch (6.35 mm) holes. Install anchors if necessary and one screw for each bracket keyslot
location.
4. Position each Power Center keyslot (top and lower) slot over the two mounting screws just installed.
Tighten the two screws to secure the enclosure.
5. Install and tighten four mounting screws (two in the top and two in the lower bracket).
Bracket screw hole
Bracket keyslot
Bracket screw hole
Cover screw hole
Bracket screw hole
Bracket keyslot
Bracket screw hole
To Next Page
Loading...
Need help?
General
