10
IntelliFloXF
™
and IntelliProXF
™
Variable Speed Pump Installation and User’s Guide
Pump Menu: Settings
Pump Address
The default pump address is #1 and needs to be changed when there is more than one
IntelliFloXF
™
or IntelliProXF
™
(or IntelliFlo
®
and IntelliPro
®
) pump on an automation system.
Change the address to allow the automation system to send a command to the correct pump.
Use this setting if your pump is connected via the RS-485 COM port to an IntelliTouch
®
,
EasyTouch
®
, SunTouch
®
or IntelliComm
®
system. For EasyTouch
®
, SunTouch
®
or IntelliComm
®
the pump only communicates with address #1. The pump address can be set from 1-16. The
IntelliTouch
®
can communicate only to four (1-4) pumps.
Note: IntelliFloXF
™
or IntelliProXF
™
pumps cannot be connected in series with other pumps.
1. Be sure the green power LED is on and the pump is stopped.
2. Press Menu.
3. Press Select for “Settings”. Press Select again to select “Pump Address”.
4. To change the pump address, press Select,
5. Press Up or Down arrows to change the address number from 1-16.
6. Press Enter to save. To cancel any changes, press Escape to exit without saving.
7. Press Escape to exit.
Set Time
The time controls all scheduled times, functions, and programmed cycles and stores the correct
time for up to 96 hours after power is turned off. Reset if the power is off longer than 96 hours.
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select “Settings”.
4. Use the Up or Down arrows to scroll to “Set Time” and press Select .
5. Press Select again and use Up or Down arrows to set the time.
Note: To change AM/PM, increase or decrease numbers until the desired time is displayed.
6. Press Enter to save. To cancel any changes, press Escape to exit without saving.
7. Press Escape to exit.
Set AM/PM or 24 Clock
To change the time from a 12 hour clock (AM/PM) to a 24 hour clock:
1. Press Menu.
2. Press Select to select “Settings”.
3. Use the Up or Down arrows to scroll to “AM/PM.”
4. Press Select to change the setting.
5. Press Up or Down arrows to choose between 24 hr. and AM/PM.
6. Press Enter to save. To cancel any changes, press Escape to exit without saving.
7. Press Escape to exit.
MENU
SETTINGS
To Next Page
Loading...
Need help?
General
