To Next Page

To Previous Page

IntelliFloXF

™

and IntelliProXF

™

Variable Speed Pump Installation and User’s Guide

Set Minimum Speed (RPM)

The minimum pump speed can be set from 450 RPM to 1700 RPM. The default setting is

450 RPM.

1. Check that the green power LED is on.

2. Press Menu.

3. Press Select to select “Settings”.

4. Use the Up or Down arrows to scroll to “Set Min Speed”.

5. Press Select to change the setting. The cursor will appear in the ﬁ rst number column.

6. Press the Up or Down arrows to change the minimum speed setting from 450 to 1700 RPM.

7. Press Enter to save. To cancel, press Escape to exit edit mode without saving.

8. Press Escape to exit.

Set Maximum Speed (RPM)

The maximum speed can be set from 1900 RPM to 3450 RPM (default is 3450). Use this setting

is to set the maximum running speed of the pump. When the pump is set to Priming “Enabled”,

the pump will ramp up to and run at this speed to prime. A service professional must set the

Maximum Speed of the pump to not exceed the maximum ﬂ ow rate of the system on which it

will operate.

CAUTION: The Maximum Flow rate setting should be set so the system never operates at or

above 25” of Hg vacuum.

1. Check that the green power LED is on.

2. Press Menu.

3. Press Select to select “Settings”.

4. Use the Up or Down arrows to scroll to “Set Max Speed”.

5. Press Select to change. The cursor will appear in the ﬁ rst number column (ones).

6. Press Up or Down arrows to change the maximum speed setting from 1900 to 3450 RPM.

7. Press Enter. Press Escape to exit. To cancel, press the Escape to exit without saving.

Pump Menu: Settings

SETTINGS

Pentair IntelliFloXF User Manual

Questions and Answers: