Pentair IntelliFloXF User Manual

13
IntelliFloXF
™
and IntelliProXF
™
Variable Speed Pump Installation and User’s Guide
Entering Password
1. Press any button (besides the speed button) to prompt the screen for a password.
2. To enter password, use the left and right arrows to move the cursor and the Up and Down
arrow button to scroll through the digit then press the Enter button to confi rm.
Password Protection
The default setting for password protection is disabled. When this feature is enabled, the
pump display will prompt for the password before allowing access to the control panel and
buttons. The entered password is any combination of four (4) digits.
• Password protection can always be turned off by pressing Start/Stop.
• Password protection cannot be turned back on with Start/Stop while running in manual
mode.
• Pressing Start/Stop when the pump is off will return it back to the Running Cycles Mode
and run at the next scheduled run time. If the present time is within the scheduled run
time, the pump will run the scheduled speed.
• All functions including programming are disabled in
Password Protection Mode.
• Screen will read “Enter Password” if any button other
than the Start/Stop button is pressed
• Key icon displayed in the upper left side of the
screen when Password Protection is on.
Setting Password
1. Check that the green power LED is on.
2. Press Menu. Press Select to select “Settings”.
3. Use the Up or Down arrow to scroll to “Password”.
4. Press Select. The default setting is “Disabled”.
5. Press Up or Down arrow to change the setting to “Enabled” and press Enter to save.
6. Press the Down arrow. “Password Timeout” is displayed.
7. The factory default time is 10 minutes. This means the pump will go into Password Protection
mode 10 minutes after the last control panel key is pressed.
8. Press Select to change time setting from 1 minute to 6 hours and press Enter to save.
9. Press Down arrow and then press Select on “Enter Password” to change the setting.
10. Press the Left or Right arrows to move cursor and press Up or Down arrow to change
password number to desired setting.
11. Press Enter to save. To cancel any changes, press Escape to exit without saving.
12:15
750 RPM
750 RPM
Actual Speed
Running Speed 1
Password
Protection
Enabled
Pump Menu: Settings
MENU
SETTINGS

Pentair IntelliFloXF Specifications

General

Brand	Pentair
Model	IntelliFloXF
Category	Water Pump
Language	English