Pentair IntelliPool - IntelliPool Account Value Correction; Correcting Sensor Read Values

40
7
7.1
1.4 %
!
English
Despite calibration of the measurement sensors, a value may be out of step with another measurement marker (usual thermometer, etc.). For this,
you have the option of voluntarily correcting certain values and/or air and water temperature units (pre-set in the factory at °C) and the conductivity
(pre-set in the factory in µS).
1 - Put the switch in Calib. mode (on the back of the indoor display)
2 - Follow the procedure.
3 - When the modifications are approved, put the switch back in ON mode.
Correction of values from the IntelliPool account
English
Correction of the read values: 45000
Next
Choose...
Choose...
Conductivity
pH
Probe > Initialisation> Settings > Correction > Result
Correction of the read values: 45000
NextPrevious
Probe > Initialisation > Settings Correction > Result
Settings
Correction of the read values: 45000
Probe > Initialisation > Settings > Correction Result
Result
Correction of the read values: 45000
Next
Previous
Probe > Initialisation > Settings > Correction > Result
In progress
Modification(s) are being processed
Setpoint
Coecient
Correction of the read values: 45000
Next
Previous
Probe > Initialisation > Settings > Correction > Result
Initialisation
Modification(s) are being processed
Initialisation of the correction
Choice of probe
Modification(s) are being processed
Correction approved
Setpoint
Previous
In progress