Pentair Pentek Series - Page 20

19
SECTION 5: XE Series 4” Submersible Motors
3.00 (7.62)
1.508 (38.30)
1.498 (38.05)
0.6255 (15.89)
0.6245 (15.86)
14 Teeth 24/48 Pitch
30 Degee Pressure Angle
Min 0.50 (23.1) Full Spline
ANSI B92.1 Compliant
(4) 5/16 - 24
UNF-2A Threaded
Studs on 3” (76.2)
Dia. Circle
Sand Boot
3.750 (95.2)
1.5 (38.1)max.
Length
4” Motor
All dimensions
in inches (mm)
Shaft free end-play
.005 -.040 (.127 - 1.02)
0.97 (24.6) max
0.79 (20.1) min
Figure 5-1: XE Series 4” Motor Dimensions – Single and Three Phase
XE Series Motors