Pentair Pentek Series - Product Description and Specifications

48
SECTION 8: Pentek Intellidrive
™
Variable Frequency Drives
Specifications/Ratings
Input Voltage ...................... 1-Phase 230VAC Nominal (190–265VAC)
Input Frequency
..................................................................... 50/60Hz
Ambient Temper
ate Range
.................... -4 to 122 °F (-20° t
o 50 °C)
Output Connections .........................3-Phase, 3-Wire/1-Phase or
1-Phase/2-Wire
Max Motor Cable Length .................................................... 1,000 feet
Enclosure
........................................................................................ 3R
Table 1 - Specifications
Model Motor Type
HP
Range
Input
Voltage
Maximum
Output
AMPS
Enclosur
e
Type
PID10
2-WIRE* 1-PHASE
0.5–1 HP
190V –
265V
9.5A
NEMA 3R
outdoor
3-WIRE* 1-PHASE
7.5A
3-PHASE 5A
PID20
2-WIRE*
1-PHASE 0.5–1.5 HP
11A
3-WIRE*
1-PHASE
0.5–2 HP
13.5A
3-PHASE
8.5A
PID50
3-PHASE 0.5–5
HP
18A
2-WIRE 0.5 - 1.5 11A
3-WIRE
0.5-2 13.5A
* Select drives by S.F. amps of pump motor.
The Pentek Intellidrive is specifically designed to
operate 4” submersible pumps and 3-phase above
ground pumps in water well and residential booster
applications. Each Drive is rated for maximum output
amp rating. Any use of Drive outside of intended
design parameters will void warranty. If Drive is used
with above ground motors not rated for a Variable
Frequency Drive, maximize motor life by limiting lead
length to 25 ft. Refer to pump Owner’s Manual and the
National Electrical Code for proper wire size.
Each carton contains:
• Pentek Intellidrive Variable Frequency Drive
•PressureTransducer
•10’PressureTransducerCable
•QuickStartGuide
6004 0509
Transducer; install in straight
pipe downstream of tank, at
least one foot away from
pipe fittings on each side.
Gnd
(3 phase only)
PENTEK
INTELLIDRIVE™
Gnd
PIDXX
Product Family
PID - PENTEK INTELLIDRIVE
HP Range
10 = up to 1.0 HP
20 = up to 2.0 HP
50 = up to 5.0 HP
The PID10 will operate a 1-Phase 2-Wire, 1-Phase
3-Wire, and 3-Phase motor up to 1HP.
The PID20 will operate a 1-Phase 2-Wire up to 1.5HP
and a 1-Phase 3-Wire or 3-Phase motor up to 2HP.
The PID50 will operate a 1-Phase 2-Wire up to 1.5HP,
1-Phase 3-Wire up to 2HP, or 3-Phase motor up to 5HP.
8.2 Description
Figure 1 - A typical residential installation layout