Pentair Pentek Series - Step-by-Step Programming Instructions

73
9.6.4 Step By Step Programming
Instructions
STEP 1
Initial Startup Panel Display
Upon initial drive power-up the installer will be prompted
to run the Pentek
®
Assistant. Scroll to YES and then
select OK. Wait while the program loads. On subsequent
startups, the Pentek Assistant can be found in the
ASSISTANTS menu.
STEP 2
Motor Selection Screen
Scroll to select the type installation and then press OK.
STEP 3
Motor Voltage Screen
The screen shows motor voltage. Scroll to select the
correct voltage for your motor as stated on the motor
nameplate. This sample shows 460 volts. Press SAVE.
STEP 4
Motor Current Screen
Enter the motor current from the motor nameplate
(not maximum amps). Scroll to select the current and
pressSAVE unless it is a submersible (more than 1.15).
STEP 5
Motor Frequency Screen
Enter the motor frequency (Hz) from the motor
nameplate. Scroll to select the frequency and select
SAVE.
STEP 6
Motor Speed Screen
Enter the motor speed (RPM) from the motor nameplate.
Scroll to select the speed and press SAVE. The sample
here shows 3450 RPM.
EXIT
00:00
SAVE
REM
PAR EDIT
460 V
9905 MOTOR NOM VOLT
EXIT
00:00
SAVE
REM
PAR EDIT
3.8 A
9906 MOTOR NOM CURR
EXIT
00:00
SAVE
REM
PAR EDIT
60.0 Hz
9907 MOTOR NOM FREQ
EXIT
00:00
SAVE
REM
PAR EDIT
3450 rpm
9908 MOTOR NOM SPEED
EXIT
00:00
OK
Please Select Mtr Type
Above Ground
Submersible
EXIT
00:00
OK
REM
CHOICE
Do you want to run
the PENTEK
assistant?
Ye s
No
SECTION 9: PPC Series 50/60 Hz Variable Frequency Drives
PPC Series
VFD