50
UNLOADING A FILM
1 The film automatically
rewinds at the end of the
roll.
During rewinding, blinks
on the LCD panel, indicating that
the film is being rewound, the
exposure counter counts frame
numbers in reverse.
2 When the film is fully
rewound, blinks on the
LCD panel.
3 Open the back cover and
remove the film.
✍
MEMO
• When removing the film from the camera, avoid direct sun light.
• A roll of 24-exposure film takes about 13 seconds to rewind.
• Before opening the back cover, check that is blinking.
• The shutter may be released a frame or more after the specified
number of frames have been used as indicated on the film cartridge.
However, those extra frames may be lost in processing. When you take
important pictures, rewind the film when the film reaches the number of
frames indicated on the film cartridge (see page 51) and load a new
film.
• If the custom function [CF10] is set to [2], the film is not automatically
rewound. See pages 134 and 139.
Step 10
To Next Page
Loading...
Need help?
General
