62
2 Take the first picture.
The frame number and on
the LCD panel blink.
Take the second picture.
The frame number stops
blinking and the film is
advanced to the next frame,
then the camera returns into
single-frame drive mode.
SELECTING A DRIVE MODE
✍
MEMO
• To expose the third shot, press the drive mode button after step 2- ,
then go to step 2- . To expose more shots, always press the drive
mode button to let stop blinking in advance of taking the next shot.
If you do not press the drive mode button before taking the next shot,
that shot will be the last one.
• The multi-exposure shooting mode remains in effect even after the
main/preview switch is turned off. To cancel the multi-exposure shooting
mode, remove the batteries once and load again. After replacing the
batteries, be sure to set the time and date imprinting mode again. See
page 28.
To Next Page
Loading...
