134
Shooting Functions
4
4
Aim the camera at the subject and press the shutter
release button halfway.
The following indicators appear on the status screen.
q: Shake Reduction On + Horizon Correction On
r: Shake Reduction Off + Horizon Correction On
• Set [Shake Reduction] to l (Off) when using the camera with a tripod or
when this function is not needed.
• [Shake Reduction] is automatically set to l (Off) and cannot be selected
in the following situations.
- Self-timer shooting
- Remote control shooting
- Bulb shooting
- HDR Capture
- Mirror lock-up shooting
- Wireless mode with an external flash
•
The Shake Reduction function will not fully work (for about 2 seconds) right
after turning on the camera or restoring from Auto Power Off. Wait for the
Shake Reduction function to become stable before gently pressing the shutter
release button to take a picture. When you press the shutter release button
halfway and if
k
appears in the viewfinder, the camera is ready to take a
picture.
• The Shake Reduction function is available with any Q compatible
PENTAX lens. However, when the aperture ring is set to other than the s
(Auto) position or a lens without an s position is used, the camera does not
operate unless [37. Using Aperture Ring] in the [A Custom Setting 6] menu
is set to [Permitted]. Set this beforehand. However, in such cases some
functions are restricted. Refer to “Notes on [37. Using Aperture Ring]” (p.294)
for details.
To Next Page
Loading...
