174
Using the Flash
5
You can use [P-TTL auto] with the AF540FGZ, AF360FGZ, AF200FG or
AF160FC flash unit. The flash pre-flashes before the actual flash and
confirms the subject (the distance, brightness, contrast, whether it is
backlit, etc.) using the camera 77-segment metering sensor. The flash
output for the actual flash is adjusted based on the information obtained
from the pre-flash, enabling flash photography with more appropriate
exposure for the subject than with normal TTL auto.
1
Remove the cover of the hot shoe and attach the external
flash.
2
Turn on the camera and the external flash.
3
Set the external flash mode to [P-TTL auto].
4
Confirm that the external flash is fully charged and then
take the picture.
Using P-TTL Auto Mode
About the Display Panel for AF360FGZ
The AF360FGZ itself does not have the function to set the FORMAT
size to [DIGITAL]. However, when it is used with a SLR Digital
Camera, the difference in focal length between 35 mm film camera
and the Q is automatically calculated based on the difference in
angle of view and is displayed on the panel (when using DA, DA L, D
FA, FA J, FA or F lens).
The conversion indicator appears and the format size indicator
disappears when the exposure metering timer of the
Q is on (it
returns to 35 mm format display when the exposure metering timer is
turned off).
* Using wide-angle panel
Lens focal length
85mm 77mm 50mm 35mm 28mm 24mm 20mm 18 mm
Exposure metering
timer Off
85mm
70mm 50mm
35mm
28mm 24mm
*
Exposure metering
timer On
58mm
48mm 34mm
24mm
19mm 16mm
*
To Next Page
Loading...
