LOADING THE BATTERIES
1. Open the battery chamber
cover by using a coin, etc.
as shown in the illustration.
3. Turn the battery chamber
cover screw in the direction
of the arrow to lock it
securely.
2. Load two 3V lithium batter-
ies (CR2) or equivalent as
shown in the illustration.
12
BASIC OPERATION (PREPARATION)
• When the batteries are replaced, the camera
settings such as the audible PCV signal switch-
ing, exposure compensation value, red-eye
reduction flash function, self-timer, remote con-
trol and auto-popup flash function of the built-in
flash will be re-set.
• The optional “AA-Battery Pack FG” is also avail-
able for this camera instead of using the lithium
batteries.
• Replace two batteries at the same time. Do not
mix battery brands, type or an old battery with a
new one. It may cause explosion or overheating.
To Next Page
Loading...
