MEMORY LOCK FUNCTION
63
ADVANCED OPERATIONS
Purpose
The memory lock function enables an exposure
level lock function to get a correct exposure from a
neutral mid-tone area of a high-contrast scene.
To set the Memory Lock:
1. Position the area to be measured in the
viewfinder metering area and depress the
memory lock button [ ML ].
2. [ ] is displayed in the viewfinder and audi-
ble PCV signal can be heard. The measured
exposure level is memorized for 20 sec-
onds.
3. Recompose the image in the viewfinder and
take the picture.
• If the shutter release button is depressed
halfway down while the memory lock timer is
operating, the memorized meter reading will
remain even if the memory lock button is
released.
• When the memory lock button is depressed, the
audible PCV signal is heard.This PCV signal can
be turned off. See page 62.
• The auto-popup built-in flash function does not
work while the memory lock is used.
• The memory lock function dose not operete in
the Auto Picture Mode.
To Next Page
Loading...
Need help?
General
