Adjusting the hour/minute
1. Press the DATE button repeatedly until the
time is displayed.
2. Press the SELECT button to make the hour,
minute or second ( : ) you want to change
blink. The digits blink in the following order.
Hour - Minutes - : - Hour
3. Change the data ( hour or minute ) with the
ADJUST button.
4. To change the second ( : ), press the
SELECT button until “ : “ will blink, and then
press the ADJUST button in sync with a
time signal to set the second to zero.
5. Press the SELECT button to stop the adjust-
ed hour/minute from blinking.
Operational precautions
• The working temperature for data printing is 0°C
- 50°C (32˚F - 122˚F).
• Use DX-coded films with ISO rating from 25 -
1600.
• If high-speed film with an ISO rating of 1000 or
faster is used, the imprinted characters may blur.
• If film with ISO rating of 50 or slower is used, the
printed characters may be dark or dim.
• If you release the shutter while the blinking data
is being corrected, the data cannot be imprinted.
72
ADVANCED OPERATIONS
To Next Page
Loading...
