* When the shutter release button is depressed
halfway down, the shutter speed and aperture
value will be displayed in the viewfinder and on
the LCD panel. The bar underneath the aperture
value indicates that you can change the aperture
setting.
• The Aperture-Priority AE Mode can also set
when the lens aperture rung is set the desired f-
stop other than [ A ]. Set the mode dial to either
[ AUTO PICT ], [ ], [ ],[ ], [ ], [ ] or
[].
• The approximate aperture indication appears in
the viewfinder. It may not the same indication as
you select the lens aperture.
• When lenses other than an F or FA series are
used,no aperture indication will appear
* Exposure Warning
If the subject is too bright or too dark, the selected
shutter speed will blink in the viewfinder and on
the LCD panel as a warning as shown. When the
subject is too bright, choose a smaller aperture, if
available; when it is too dark, choose a larger
aperture, if available. When the shutter speed indi-
cation stops blinking, you can take the picture. If
both shutter and aperture blink, it means that the
exposure is out of metering range, unable to
obtain a correct exposure even if the aperture is
adjusted. Select a darker subject if it is too bright,
or use a flash if it is too dark.
55
ADVANCED OPERATIONS
To Next Page
Loading...
Need help?
General
