5. The dot displayed in the center of the bar
graph indicates the correct exposure.
* When the dots are displayed to the [ + ] side on
the bar graph, it indicates overexposure and
when the dots are displayed to the [ - ] side, it
indicates underexposure.
• Moving one dot on the bar graph indicates 0.5
step (0.5EV).
• When under or over exposure is set beyond + 2
or - 2 steps (3EV), [ + ] or [ - ] indicator will blink.
• When the shutter release button is depressed
halfway down, the shutter speed and aperture
value will be displayed in the viewfinder and on
the LCD panel. The bar underneath the aperture
value indicates that you can change the aperture
setting.
• When lenses other than an F or FA lens is used,
no approximate aperture indication will appear in
the viewfinder.
• The memory lock does not operate in the
Metered Manual Mode.
• The indicator in the viewfinder turns to orange
when the shutter speed changes to a slower
shutter speed which causes camera shake.
* Exposure Warning
If the subject is too bright or too dark, both shutter
speed and aperture setting will blink in the
viewfinder as a warning as shown. It means that
the exposure is out of metering range, unable to
obtain a correct exposure even if the aperture is
adjusted. Select a darker subject or use a flash if
it is too dark.
59
ADVANCED OPERATIONS
CORRECT UNDER OVER
To Next Page
Loading...
Need help?
General
