Pentax Optio T30 - Taking Pictures with the Built-In Photo Frames

Composing Your Shot
52
3
Taking Pictures
You can take pictures using any of the 3 decorative frames stored in the
camera.
1 In Capture mode, touch the LCD monitor.
The [Capture Toolbar] appears.
2 Touch the Shooting Mode. (e.g.
b).
• The icon of the currently selected shooting
mode appears on the [Capture Toolbar].
• The [Capture Palette] appears.
• If the Y icon does not appear, touch the
arrow icons (qr) to advance the screen.
3 Double-touch the Y icon.
• The Frame Selection screen appears.
• Touch an icon with the guide checkbox
checked to display the guide display.
4 Touch the frame you want to use.
The Frame Composite screen appears.
5 Touch [OK].
• The setting is saved and the camera returns to Capture mode.
• You can also touch the arrow icons (qr) to select a different frame.
6 Press the shutter release button halfway.
The focus frame on the LCD monitor turns green if the subject is in focus.
7 Press the shutter release button fully.
The picture is taken.
Memo
• The frames used in this function are stored in the camera’s built-in memory/
SD Memory Card.
• The number of recorded pixels is fixed at h.
• If the number of recorded pixels is other than h before using this function,
the setting returns to the previous value when you exit the Frame Composite
function by setting any other shooting mode.
Taking Pictures with the Built-in Photo Frames
2/2
2/2
2/2
Capture Palette
Capture Palette
Capture Palette
Guide
Guide
Guide
Cancel OK
FRAME001