Pentax Optio W60 - Quick Start; Taking Still Pictures

43
2
Quick Start
Quick Start
Taking Still Pictures
The standard procedure for taking still pictures is described below. The
flash fires automatically depending on the light conditions.
1 Press the power switch.
The camera turns on and is ready to take
still pictures. In this manual, this is called
Still Picture Capture mode.
2 Confirm the subject and shooting
information on the display.
The focus frame in the middle of the display
indicates the zone of automatic focusing.
You can change the captured area by pressing the Zoom/w/x button
to the left or right.
x : enlarges the subject
w : widens the area that is captured by the camera
3 Press the shutter release button halfway.
The focus frame on the display turns green if the subject is in focus.
4 Press the shutter release button fully.
The picture is taken.
The image appears on the display for one second (Instant Review) and
is saved to the SD Memory Card or built-in memory. (p.44)
Press the Green button to switch to the 9 (Green) mode and let the
camera set all the shooting functions automatically. (p.66)
Power switch
Shutter release button
Zoom/w/x button
14:25
1 4:25
14:25
38
3 8
38
07/07/2008
0 7/07/ 2 0 0 8
07/07/2008
Focus frame