304
9
Appendix
- In the woods
- Near mobile phones that use the 1.5 GHz band
• When the GPS function is set to on, the camera performs positioning
regularly even if it is turned off. Make sure to set [GPS Setting] to P (Off)
(p.305) before turning off the camera when taking it where using electronic
products is prohibited, such as hospitals or airplanes.
• Positioning may take few minutes when using the GPS function for the first
time, after not positioning for a long while, or after changing the battery.
• The Geodetic system for this camera’s GPS function uses the World
Geodetic System 1984 (WGS 84).
• The location information on images cannot be erased. Make sure to set
[GPS Setting] to P (Off) before taking pictures if you intend to put them on
the internet without disclosing their location.
• Using GPS is prohibited in some countries or regions. Contact appropriate
embassy or travel agent before travelling with a GPS camera.
• Do not carry the camera in a metal container if the positioning function is
running. If the camera is covered with metal, the positioning function
cannot work.
• In the following situations, the camera cannot receive GPS data. It starts
positioning again if it is removed from the following situations:
- While recording an image or a movie
- During a slideshow or while playing back a movie
- While doing settings on the camera’s setting menu
- When the alarm is ringing
- When the camera is connected to a computer with a USB cable
- When the camera is connected to AV equipment with an AV or HDMI
cable
- For a minute after changing the battery
Hereby, HOYA CORPORATION, declares that this GPS Module Circuit
Board/SG561_TB1 is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.
For a full version of the Declaration of Conformity (DoC), please refer to
http://www.pentax.jp/english/.
This part applies only to Optio WG-1 GPS camera
OptioWG1_eng.book Page 304 Friday, March 11, 2011 4:10 PM
To Next Page
Loading...
