104
3
Taking Pictures
5
Press the shutter release button fully.
Countdown starts and the remaining seconds are displayed on the screen.
If you select g
The self timer lamp and all of the macro lights turn on.
From 4 seconds before shooting, the macro lights turn off in order
from the top right.
From 3 seconds before shooting, the self timer lamp also blinks.
If you select Z
The self timer lamp and the macro lights blink.
The picture is taken after a countdown of either ten seconds or two seconds.
Pictures are taken continuously as long as the shutter release button is
pressed.
* The number of images that can be shot continuously and the interval between
shots depend on shooting situations.
Focusing may be compromised if you move the camera while the self-
timer lamp is blinking when taking still pictures.
•In C (Movie) mode, recording will start after ten seconds (or two
seconds).
• Press the shutter release button halfway while the self-timer is engaged
to stop the countdown and press fully to restart the countdown.
• Z cannot be selected while 9 (Green) mode is in default setting.
Select Z in another shooting mode and then switch the shooting mode
to 9.
• The self-timer lamp does not flash in e (Pet) mode.
• In the following situations, the macro lights remain turned on
regardless of the countdown.
- In the Digital Microscope mode
- When [Macro Light] on the [A Rec. Mode] menu is set to O (On)
Taking a Series of Pictures (Continuous
Shooting/Burst Shooting)
j
Continuous
Shooting
Each time a picture is taken, the image is saved in the memory
before the next image is taken. The higher the image quality,
the longer the interval between shots.
c
Burst
Shooting
The number of recorded pixels is fixed at f (2592×1944)/
(2592×1464) and the interval between shots is shorter
than “Continuous Shooting”.
OptioWG1_eng.book Page 104 Friday, March 11, 2011 4:10 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
