USER MANUAL
Peplink Balance Series
17.1.1 Access Point Information
Access Point can be assigned with different AP Profiles created in section 17.5. Click Control Panel on
the Dashboard and the following will be shown.
If there is a “*” next to the channel information, that means the AP One is configured to select a channel
automatically.
To apply an AP Profile, check the box(es) to choose the desired Pepwave AP device(s), and then choose
a desired AP Profile in the dropdown list under the devices list. Press Yes to confirm the change.
Once the change is confirmed, the new AP Profile will be applied to the selected device(s). Changes will
be activated immediately.
To view the device detail, click the corresponding device’s name and you will see the following screen.
http://www.peplink.com -118 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
