peplink 20 - Dynamic DNS Settings

USER MANUAL
Peplink Balance Series
11.6 Dynamic DNS Settings
Peplink Balance provides the functionality to register the domain name relationships to dynamic DNS
service providers. Through registration with dynamic DNS service provider(s), the default public Internet
IP address of each WAN connection can be associated with a host name. With Dynamic DNS service
enabled for a WAN connection, you can connect to your WAN's IP address from the external even if its IP
address is dynamic. You have to register for an account from the listed dynamic DNS service providers
before enabling this option.
If the WAN connection's IP address is a reserved private IP address (i.e. behind a NAT router), the Public
IP of each WAN will be automatically reported to the DNS service provider.
Either upon a change in IP addresses or every 23 days without link reconnection, Peplink Balance will
connect to the dynamic DNS service provider to perform an IP address update within the provider’s
records.
The settings for dynamic DNS service provider(s) and the association of host name(s) are configured via
Network > Interfaces > WAN Settings > Dynamic DNS Settings
If your desired provider is not listed, you may check with
DNS-O-Matic. This service supports updating 30
other dynamic DNS service providers.
(Note: Peplink is not affiliated with DNS-O-Matic)
Dynamic DNS Settings
Service Provider
This setting specifies the dynamic DNS service provider to be used for the WAN based
on supported dynamic DNS service providers:
• changeip.com
• dyndns.org
• no-ip.org
• tzo.com
• DNS-O-Matic
Select Disabled to disable this feature.
User ID / User / Email
This setting specifies the registered user name for the dynamic DNS service.
http://www.peplink.com -72 / 207 - Copyright © 2013 Peplink