peplink 20 User Manual

USER MANUAL
Peplink Balance Series
21.6 SNMP
SNMPor Simple Network Management Protocolis an open standard that can be used to collect
information about the Peplink Balance unit.
SNMP configuration is located at:System> SNMP
SNMP Settings
SNMP Device
Name
This field shows the router name defined in System > Admin Security.
SNMP Port
This option specifies the port which SNMP used. The default port is set as 161.
SNMPv1
This option allows you to enable SNMP version 1.
SNMPv2
This option allows you to enable SNMP version 2.
SNMPv3
This option allows you to enable SNMP version 3.
http://www.peplink.com -167 / 207 - Copyright © 2013 Peplink

peplink 20 Specifications

General

Load Balancing	Yes
VPN Support	Yes
Power over Ethernet (PoE)	No
LAN Ports	4
LAN Interface	4x GE
Wi-Fi Standard	802.11ac
PepVPN/SpeedFusion Throughput (AES 256	200 Mbps
Power Input	12V DC