USER MANUAL
Peplink Balance Series
To reorder a rule’s position, just drag on the rule by holding the left mouse button, move it to the desired
position and drop it by releasing the mouse button.
To remove a rule, click .
Rules are matched from top to the bottom.If a connection matches any one of the upper rules, the
matching process will stop. If none of the rules is matching, the Default rule will be applied.
By default, the Default rule is Allow for both outbound and inbound accesses.
Tip
If the default inbound rule is set as Allow for NAT enabled WANs, no inbound Allow firewall rules will be required
for inbound Port Forwarding and inbound NAT Mapping rules. However, if the default inbound rule is set as
Deny, a corresponding Allow firewall rules will be required.
http://www.peplink.com -147 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
