USER MANUAL
Peplink Balance Series
High Availability Settings
High Availability
Checking this box specifies that the Peplink Balance unit is part of a High Availability
configuration.
Group Number
This setting specifies a number that identifies a pair of Peplink Balance units that operate in a
High Availability configuration.
The two Peplink Balance units in the pair must have the same Group Number value.
Preferred Role
This setting specifies whether the Peplink Balance unit operates in Master or Slave mode.
Click the corresponding radio button to set the role of the unit.
One of the units in the pair must be configured as the Master and the other unit must be
configured as the Slave
Resume Master
Role Upon
Recovery
This option is displayed when Master mode is selected in Preferred Role.
If this option is enabled, once the device is recovered from outage, it will take over and
resume its
role from the slave unit.
Configuration
Sync.
This option is displayed when Slave mode is selected in Preferred Role.
If this option is enabled and the Master Serial Number entered matches with the actual
master unit's, the master unit will automatically transfer the configuration to this unit. Please
make sure the LAN IP Address and Subnet Mask fields are set correctly in the LAN
Settings page.
You can refer to the
for the configuration synchronization status.
Master Serial
Number
If the box Configuration Sync. is checked, serial number of the Master unit is required to be
entered here.
Virtual IP
The setting specifies the LAN IP address on which the active Peplink Balance listens.
The value of Virtual IP represents a LAN IP address that is shared among the Master and
Slave units; however, at any time, only one of the two units will listen on the IP address.
If the WAN is configured in NAT mode, Default Gateway of the clients on the LAN should be
set to the virtual IP. These configurations are not required when the WAN is configured in
Drop-in mode.
LAN
Administration
IP
This setting specifies a LAN IP address to be used for accessing administration functionality.
This address should be unique within the LAN.
This setting specifies the subnet mask of the LAN.
http://www.peplink.com -151 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
