USER MANUAL
Peplink Balance Series
Problem 5
What can I do if I suspect a problem on my Internet/WAN connection?
Solution
You can test the WAN connection by Ping, which is similar to problem 4.
As we want to isolate the problems from the LAN, Ping will be performed from Peplink Balance. By using
the Ping/Tracerouteunder the tab Status of the Peplink Balance, you may able to find out the source of
problem.
Problem 6
When I upload files to a server via ftp, the transfer stalls after a few kilobytes of data are sent.What
should I do?
Solution
The Maximum Transmission Unit (MTU) or MSS setting may need to be adjusted.
By default, the MTU is set at 1440. Choose Auto for all of your WAN connections. If it does not solve, you
may try the MTU 1492 if a connection is a DSL. If problem still persists, change the size to smaller values
until your problem is resolved (e.g. 1462, 1440, 1420, 1400, etc).
http://www.peplink.com -196 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
