USER MANUAL
Peplink Balance Series
.
Connection Type
This setting specifies the utilization of the WAN connection.
The selection of Always-on results in the WAN connection to be used whenever it is
available. If Backup Priority and a priority group are selected, the WAN connection is
treated as a backup connection and is used only in the absence of available Always-on
WAN connection(s) and higher priority backup connection(s).
The default and recommended Connection Type is Always-on.
Reply to ICMP Ping
If this field is disabled, the WAN connection will not respond to ICMP Ping requests.
By default, this is enabled.
Upload Bandwidth
This setting specifies the data bandwidth in the outbound direction from the LAN through
the WAN interface. This value is provided by the ISP and should reflect the actual speed
the WAN gets.
This value is referenced when default weight is chosen for outbound traffic and traffic
prioritization. A correct value can result in effective traffic prioritization and efficient use of
upload bandwidth.
Download
Bandwidth
This setting specifies the data bandwidth in the inbound direction from the WAN interface
to the
LAN. This value is provided by the ISP and should reflect the actual speed the WAN
gets.
This value is referenced as the default weight value when using the algorithm Least Used,
or the algorithm Persistence (Auto) in Outbound Policy with Managed by Custom Rules
chosen (see Section 0).
IPv6
IPv6
IPv6 support can be enabled on one of the available Ethernet WAN ports. On this screen,
you can choose which WAN will support IPv6.
To enable IPv6 support on a WAN, the WAN router must respond to Stateless Address
Auto configuration advertisements and DHCPv6 requests. IPv6 clients on the LAN will
acquire their IPv6, gateway, and DNS server addresses from it. The device will also
acquire an IPv6 address for performing ping/traceroute checks and accepting web admin
accesses.
http://www.peplink.com -58 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
