Warnings and Safety Information
9
Safety Information
Safety Information in the Handbook
This handbook contains information and warnings that must be followed by the user
to ensure safe operation and to maintain the instrument in a safe condition.
Possible hazards that could harm the user or result in damage to the instrument are
clearly stated at appropriate places throughout this handbook.
Before using the instrument it is essential to read the manual carefully and to pay
particular attention to any advice concerning potential hazards that may arise from
the use of the instrument. The advice is intended to supplement, not supercede the
normal safety code of behavior prevailing in the user’s country.
IEC 61010 Compliance
This instrument has been designed and tested in accordance with IEC 1010-1: Safety
requirements for electrical equipment for measurement, control, and laboratory use,
and Amendment 1 to this standard.
CSA Compliance
This instrument meets the Canadian Standards Association (CSA) Standard
CAN/CSA-C22.2-1010.1: Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – General Requirements.
Electrical Protection
Insulation: Class I as defined in IEC 61010-1.
Installation Category: The instruments are able to withstand transient overvoltage
according to Installation Category II as defined in IEC 61010-1 and IEC 664.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
