Accessories
73
Accessory Installation
To operate the spectrometer with some accessories, for example the Peltier
Temperature sensor, an accessory panel kit (L6000500) is required.
Procedures for installing the accessories in the spectrometer are described in the
directions provided with the respective accessory.
To install certain accessories you need to remove the sample compartment cover.
The required procedures are described below.
In the directions provided with some sample handling accessories, reference is made
to earlier models in the Lambda Series of spectrometers. These directions are
generally applicable to the current series of instruments since the sample
compartment is standardized.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Need help?
General
