Enable I/O Failsafe
Timer
Timeout
142
Settings
Enables/disables the Failsafe Timer. This is the global setting that must be
enabled to set the Failsafe Action on the channel for digital output and relay
channels or output signal pins. When this timer expires because of no I/O
activity within the specified time interval, the Failsafe Action set for the
channel determines the action on the output. When the channel or serial signal
pin is configured for I/O extension, the timer expires there are no TCP sessions
for the specified time interval.
Default: Disabled
The number of seconds that must elapse before the channel/serial signal pin
Failsafe Action is triggered.
Range: 1-9999
Default: 30 seconds
To Next Page
Loading...
