DHCP/BOOTP
43 IOLAN DS1/TS2 User’s Guide, Version 4.3
DHCP/BOOTP Parameters
The following parameters can be set in the DHCP/BOOTP bootp file:
z SW_FILE—The full path, pre-fixed by hostname/IP address (IPv4 or IPv6), and file name of the
firmware update.
z CONFIG_FILE—The full path, pre-fixed by hostname/IP address (IPv4 or IPv6), and file name
of the configuration file. Note: these parameters include clear text user passwords.
z GUI_ACCESS—Access to the IOLAN from the HTTP WebManager. Values are on or off.
z SECURITY—Restricts IOLAN access to devices listed in the IOLAN’s host table. Values are
yes or no.
z TFTP_RETRY—The number of TFTP attempts before aborting. This is a numeric value, for
example, 5.
z TFTP_TMOUT—The time, in seconds, before retrying a TFTP download/upload. This is a
numeric value, for example, 3.
z CUSTOM_LANG—The full path, pre-fixed by a hostname/IP address (IPv4 or IPv6), and file
name of a translated language file. For example,
192.101.34.211 /accounting/Iolan_ds_german.txt.
z EXTRA_TERM1—(EXTRA_TERM2, EXTRA_TERM3) The full path, pre-fixed by a
hostname/IP address (IPv4 or IPv6), and file name of a termcap file for a specific terminal type.
To Next Page
